Panasonic Wireless 802.11 b/g Network Camera and Pet Cam (BL-C30A)

from Amazon user
1) Plug-in camera to AC and hold down the “reset” pin with a pen. My computer would not recognize the camera until I physically reset it.
2) Make sure camera switch is set to “wired”.
3) Connect the camera via Ethernet cable to you Mac.
4) Temporarily give your Mac the manual IP address 192.168.0.5 and subnet 255.255.255.0 in the Network Prefs.
5) Connect to the camera using Safari at address 192.168.0.253 – you should be able to see the settings page now.
6) Click through the setup but say “No” when it asks if you want to “go on the internet”. This will make it try to find your router (which is not on the network) so don’t do it.
7) Enter 192.168.0.253 in Safari once again and it should take you to the Network Camera page. You should have access to the camera controls after you click the “Single” tab at the top of the page. But we’re not done yet.
8) Click the Setup tab on right side of the tabbed toobar.
9) Click Static IP to load the static ip address page for the camera
10) Uncheck the “Enable” checkbox at the top. This is for Windows setup.
11) Enter an IP address in your wireless network. My network is 192.168.2.x so I gave my camera 192.168.2.253.
12) Enter your router’s address in the Default Gateway field. Example: 192.168.2.1. If you don’t do this, your camera will not be accessible from outside your wireless network!
13) Click the Wireless tab on the left navigation bar of the camera page.
14) For SSID enter the exact name of your network. This is the name you gave your wireless router when you set it up. It appears under the Airport signal strength menu with a checkbox next to it.
15) If you have security (and you should!), enter you WEP Key. Be sure to make the right selection for your wep key (ASCII, HEX, etc).
16) Click Save.
17) Edit other settings such as Date and Time
18) Disconnect the ethernet cable from the camera.
19) Flip the camera switch from Wired to Wireless
20) Unplug the camera power, replug camera power (to restart it)
21) The camera should now go through it’s blinking light procedure and if all is well you’ll get a solid green light.
22) Go to your Network Prefs and set your computer back to using your wireless router.
23) You should now be able to access your camera at the address 192.168.2.253 wirelessly now.
24) Your router blocks traffic from the internet to your camera so you cannot view the camera from outside your network. To access your camera from the internet you’ll neet to open a port on your router that maps to your camera. This can be done by setting up a “Virtual Server” (aka port forwarding) on the router. See your router’s instructions for mapping a virtual server to your camera’s IP and port.